Component Inspection
- Ignition switch "ON" and the engine "OFF" and Using a GDS, clear the DTC.
- Ignition switch "OFF".
- Disconnect the battery (-) terminal cable from the battery, and wait at least one minutes.
- Disconnect Occupant Classification System (OCS) ECU connector.
- Substitute the Occupant Classification System (OCS) ECU and check for proper operation.
- Is DTC present problem?
YES
- Substitute a known-good SRSCM, and check for proper operation. If the problem is corrected, replace SRSCM and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.
NO
- Substitute a known-good Occupant Classification System (OCS) ECU, and check for proper operation.
If the problem is corrected, replace Occupant Classification System (OCS) ECU and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.