Monitor GDS Data
- Connect GDS to Data Link Connector (DLC).
- Warm up the engine to normal operating temperature.
- Warm up the engine until engine temperature reaches up to normal condition at EV mode with engine start status.
- Using GDS, check if there is an error in LDC system.
If there is an error in LDC system, first do a troubleshooting for those system and then check A.A.F system.
- Is the same DTC displayed again?
YES
- Go to "WIRING INSPECTION " procedure.
NO
- Repair as necessary and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.