Monitor DTC Status
- Vehicle parked and Ignition switch 'ON'.
- Connect GDS and select "DTC Analysis" mode.
- Click "DTC Status" on the "Diagnostic Trouble Codes (DTC)" menu bar to see "DTC Information".
- If DTC Status is "Present" fault, then go to the next procedure, and if it is "History" fault, then clear DTC and check the same DTC reoccurs.
- Is parameter displayed "Present" fault?
YES
- Select ABS/ESP(ESC) system and check DTCs related with brake signal, wheel speed or CAN Timeout. If DTC is exist, repair as necessary and then confirm clear.
- Recheck EPB system, if C162508 is still active DTC, go to next procedure.
NO
- Fault is intermittent caused by poor contact in the sensor's and/or Control module's connector or was repaired and Control module's memory was not cleared. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage.
- Repair or replace as necessary, and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.