| DTC Strategy |
- Monitoring the EPB Switch signal
|
- EPB switch circuit open/short circuit
- Faulty EPB switch
- Driver abnormal switch control (too many activation, pull or push for long time or slowly push/pull switch)
|
| Enable Conditions |
- EPB wake-up (Ignition switch 'ON')
|
| Threshold Value |
- When the operation switch lines is opened for more than 2 seconds
- When short circuit to Ground is detected in the switch for more than 2 seconds
- When short circuit to Battery is detected in the switch for more than 2 seconds
- When the operation switch lines is short to each other during 2 seconds
- If the switch is in on position longer than 90 seconds while the vehicle speed is below 4 km/h (2.48 mi/h)
|
| Warning Lamp |
|