Repair Procedures: Removal
- Turn ignition switch OFF and disconnect the negative (-) battery cable.
- Remove the crash pad lower panel.
(Refer to Body - "CRASH PAD ")
- Remove the knee air bag.
(Refer to Restraint - "KNEE AIRBAG (KAB) MODULE ")
- Disconnect the stop lamp switch connector (A) and the brake pedal stroke sensor connector (B).
- Remove the brake pedal member mounting nut (A).
Tightening torque:
16.7 - 25.5 N.m (1.7 - 2.6 kgf.m, 12.3 - 18.8 lb-ft)
- Remove the snap pin (A) and clevis pin (B).
- Remove the mounting nuts (A) and then remove the brake pedal.
Tightening torque:
16.7 - 25.5 N.m (1.7 - 2.6 kgf.m, 12.3 - 18.8 lb-ft)