Component Inspection
- Visual check
- Check the brake pads for wear and fade.
- Check the brake disc for damage and deformation.
- Check the brake tubes for cracks, crimps and corrosion.
- Check brake hose mounting bracket for crack or deformation.
- Have any problems been found?
YES
- Repair as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure.
NO
- Fault might be intermittent caused by poor contact in the sensor's and/or ECU's connector or was repaired and ECU memory was not cleared. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and go to "Verification of Vehicle Repair " procedure.