| DTC Strategy |
- CAN message from MDPS monitoring
|
- Defected MDPS (VSM)
- Defected IBAU
|
| Enable Conditions |
- A failure is detected if a message counter of VSM message was not increased more than specific times.
- A failure is detected if the calculated and received checksum values differ more than specific times.
- A failure is detected if VSM message's diagnostic signal fault was happened more than specific times
- control in progress - 10 times
- no control: 30 times
* VSM: Vehicle Stability Management |
| MIL |
|
| Reset condition |
- Turn ignition switch off and on.
|
| Remarks |
- Fault Check Inhibit Criteria
- Vehicle speed is lower than 10 Kph.
- Before the Plug & Play confirmation phase has been completed.
|