Component Inspection
- IG "OFF".
- IG "ON".
- Connect GDS and select "Diagnostic Trouble Codes (DTCs)" mode.
- Using a GDS, Clear DTC.
- Select "Diagnostic Trouble Codes (DTCs)" mode again.
- Are any DTCs present?
YES
- Substitute with a known-good PCM (ECM) and check for proper operation. If problem is corrected, replace PCM (ECM) and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.
NO
- Fault might be intermittent and caused either by poor contact in connectors or wiring harness, or it has been repaired and control module memory is not cleared yet. Thoroughly check terminal of battery, all connectors (and connections) for looseness, bending, corrosion, contamination, deterioration, and/or damage.
- Repair or replace as necessary and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.