DTC check
- Connect GDS.
- IG "ON".
- Select "SRSCM" system.
- Using a GDS, Check DTC present.
- Are any DTCs present?
YES
- If B1620 (Internal fault-Replace SRSCM) is set, repair according to DTC diagnostic guide of SRSCM system. In a case of replacing the SRSCM, perform "longitudinal G sensor Calibration" by GDS. (DBC/HAC only, refer to C128504 )
- If B1101 (Battery Voltage High) is set or B1102 (Battery Voltage Low) is set, repair according to DTC diagnostic guide of SRSCM system. In a case of replacing the SRSCM, perform "longitudinal G sensor Calibration" by GDS. (DBC/HAC only, refer to C128504 )
NO
- Go to next step.