Monitor GDS Data
- IG "ON".
- Connect GDS to Data Link Connector (DLC).
- Start and drive vehicle in gear and maintain vehicle speed at or above 40 km/h. (24 mph)
- Monitor the "WHEEL SPEED SENSOR" parameter on the "Current Data" menu of the GDS.
Specification:
Compare with other parameters related to wheel speed sensor. If it is the same as other parameters, it is in normal condition
- Is parameter displayed within specifications?
YES
- Fault is intermittent caused by faulty IBAU or external noise, was repaired and IBAU memory was not cleared. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.
NO
- Go to next step.