Repair Procedures: Replacement

Disconnect the connector (A), then remove the wiring mounting clips.

Courtesy of HYUNDAI MOTOR AMERICA
Disconnect the hood latch release cable (A).

Courtesy of HYUNDAI MOTOR AMERICA
Loosen the mounting bolts and remove the hood latch assembly (A).
Tightening torque:

7.8-11.8 N.m (0.8-1.2 kgf.m, 5.8-8.7 lb-ft)

Courtesy of HYUNDAI MOTOR AMERICA
To install, reverse the removal procedure.
Information
- Make sure the hood latch release cable is connected properly.
- Make sure the hood locks/unlocks and opens/closes properly.
- Adjust the latch alignment.
- Replace any damaged clips (or retainers or fasteners)