LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2021 >> Ioniq Hybrid SEL >> Repair and Diagnosis >> Accessories & Equipment >> Headlights >> Adaptive Front Lighting System Diagnosis (HEV) >> DTC B2325-09: Swivel Module Fault Left >> DTC Inspection >> Monitor GDS Data >> Actuation Test

Actuation Test

  1. Connect GDS to Data Link Connector (DLC).
  2. Engine "ON".
  3. Monitor the "Main function activation status, HLL position, DBL position" parameter on the GDS.
  4. Check the operation of "DBL position-LH" use Actuation test.
  5. Is parameter displayed within specifications?

    YES 

    • Fault is intermittent caused by poor contact in the sensor's and/or AFLS ECU's connector or was repaired and AFLS ECU memory was not cleared. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and than go to "Verification of Vehicle Repair " procedure

    NO 

scientia non olet · About LEMON Manuals