Check open in LIN communication circuit 2
- Ignition "OFF".
- Disconnect AFLS ECU connector and headlamp (LH) connector.
- Measure the resistance between AFLS ECU power terminal of wiring side and headlamp (LH) power terminal of wiring side.
Specification: Approx. 0Ω
- Is the measured resistance within specification?
YES
- Substitute with a known - good headlamp (LH) assembly and check for proper operation. If the problem is corrected, replace headlamp (LH) assembly and go to "VERIFICATION OF VEHICLE REPAIR " procedure.
NO
- Check for open between AFLS ECU LIN communication circuit and headlamp (LH) LIN communication circuit.
- Repair as necessary and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.