Check open in LIN communication circuit 1
- Ignition "OFF".
- Disconnect AFLS ECU connector and headlamp (LH) connector.
- Measure the resistance between AFLS ECU LIN communication terminal of wiring side and headlamp (LH) LIN communication terminal of wiring side.
Specification: Approx. 0Ω.
- Is the measured resistance within specification?
YES
- Go to next procedure.
NO
- Check for open between AFLS ECU LIN communication circuit and headlamp (LH) LIN communication circuit.
- Repair as necessary and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.