Check short to power in LIN communication circuit 1
- Ignition "OFF".
- Disconnect AFLS ECU connector and headlamp (LH and RH) connector.
- Ignition "ON".
- Measure the voltage between (AFLS ECU or headlamp) connector LIN communication terminal of wiring side and chassis ground.
Specification: Approx. 0V
- Is the measured voltage within specification?
YES
- Go to next procedure.
NO
- Check for short to power in LIN communication circuit between AFLS ECU to headlamp (LH and RH) connector.
- Repair as necessary and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.