Check short to ground in LIN communication circuit
- Ignition "OFF".
- Disconnect AFLS ECU connector and headlamp (LH and RH) connector.
- Measure the resistance between (AFLS ECU or headlamp) connector LIN communication terminal of wiring side and chassis ground.
Specification: Infinity Ω
- Is the measured resistance within specification?
YES
- Substitute with a known - good headlamp assembly and check for proper operation. If the problem is corrected, replace headlamp assembly and go to "VERIFICATION OF VEHICLE REPAIR " procedure.
NO
- Check for short to ground between AFLS ECU LIN communication circuit and headlamp (LH and RH) LIN communication circuit.
- Repair as necessary and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.