AFLS ECU ↔ Cluster
- Ignition "OFF"
- Disconnect AFLS ECU connector and Cluster connector.
- Measure the resistance between CAN-HIGH terminal of AFLS ECU harness connector and CAN-HIGH terminal of Cluster.
- Measure the resistance between CAN-LOW terminal of AFLS ECU harness connector and CAN-LOW terminal of Cluster.
Specification: Below 1Ω
- Is the measured resistance within specification?
YES
- Substitute with a known - good ECU (AFLS ECU or Cluster) and check for proper operation. If the problem is corrected, replace ECU and go to "VERIFICATION OF VEHICLE REPAIR " procedure.
NO
- Check for open/short in harness.
- Repair as necessary and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.