LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2021 >> Ioniq Hybrid SEL >> Repair and Diagnosis >> Accessories & Equipment >> Headlights >> Adaptive Front Lighting System Diagnosis (HEV) >> DTC B1301-87: Steering Angle Signal Fault >> Wiring Inspection >> CAN Communication Circuit Inspection >> AFLS ECU ↔ Steering Angle Sensor

AFLS ECU ↔ Steering Angle Sensor

  1. Ignition "OFF"
  2. Disconnect Steering angle sensor connector and AFLS ECU connector.
  3. Measure the resistance between CAN-HIGH terminal of Steering Angle Sensor harness connector and CAN-HIGH terminal of AFLS ECU harness connector.
  4. Measure the resistance between CAN-LOW terminal of Steering Angle Sensor harness connector and CAN-LOW terminal of AFLS ECU harness connector.

    Specification:  Below 1Ω

  5. Is the measured resistance within specification?

    YES 

    • Substitute with a known - good ECU (AFLS ECU or Steering Angle Sensor and check for proper operation. If the problem is corrected, replace ECU and go to "VERIFICATION OF VEHICLE REPAIR " procedure.

    NO 

scientia non olet · About LEMON Manuals