Subwoofer Speaker Circuit Inspection
- Ignition "OFF"
- Disconnect Battery (-) terminal.
- Refer to "SPEAKERS and, EXTERNAL AMP " and disconnect Subwoofer Speaker and AMP connector.
- Measure resistance between + terminal of Subwoofer Speaker harness connector and + terminal of AMP harness connector.
- Measure resistance between - terminal of Subwoofer Speaker harness connector and - terminal of AMP harness connector.
Specification : Approx. below 1Ω
- Is the measured value within specification?
YES
- Go to "COMPONENT INSPECTION " procedure.
NO
- Repair open or short in circuit and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.