Component Inspection
- Ignition "OFF"
- Refer to "SPEAKERS " and disconnect Subwoofer 2 Speaker connector.
- Measure the resistance between + terminal and - terminal of Subwoofer 2 Speaker.
Specification : Approx. 1.7~2.3Ω (20°C) (68°F)
- Is the measured value within specification?
YES
- Carefully re-do this troubleshooting guide steps.
- If problem still occurs, replace AMP and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.
NO
- Carefully re-do this troubleshooting guide steps.
- If no problems were found with the circuits or connectors, replace the speaker and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.