Front MID Range Speaker LH Inspection
- Ignition "OFF"
- Disconnect Battery (-) terminal.
- Refer to "SPEAKERS and, EXTERNAL AMP " and disconnect Front MID Range Speaker LH and AMP connector.
- Measure resistance between MID FL+ terminal of Front MID Range Speaker LH harness connector and MID FL+ terminal of AMP harness connector.
- Measure resistance between MID FL- terminal of Front MID Range Speaker LH harness connector and Pin MID FL-terminal of AMP harness connector.
Specification : Approx. below 1Ω
- Is the measured value within specification?
YES
- Go to "COMPONENT INSPECTION " procedure.
NO
- Repair open or short in circuit and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.