LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2021 >> Ioniq Hybrid SEL >> Repair and Diagnosis >> Accessories & Equipment >> Collision/Avoidance >> Blind Spot Detection Diagnosis - Left (HEV) >> DTC C2706-42: Software Version LH/RH Unmatching >> DTC Inspection >> Monitor GDS Data

Monitor GDS Data

  1. Connect GDS to Data Link Connector(DLC).
  2. IG key "ON" -> "ON".
  3. Monitor diagnostic trouble code and present of trouble code.
  4. Are any DTCs present?

    Using a GDS, Check if the same DTC re-sets after clearing DTC.

  5. Is the same DTC detected again?

    YES 

    • Substitute with a known-good "BSD ECU(LH/RH)" and check for proper operation. If the problem is corrected, replace "BSD ECU(LH/RH)" and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.

    NO 

scientia non olet · About LEMON Manuals