LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2021 >> Ioniq Hybrid SEL >> Repair and Diagnosis >> Accessories & Equipment >> Collision/Avoidance >> Blind Spot Detection Diagnosis - Left (HEV) >> DTC C1625-87: CAN Time-Out ABS/ESC(ESP) >> DTC Inspection >> Monitor GDS Data

Monitor GDS Data

  1. Connect GDS to Data Link Connector(DLC).
  2. IGN "ON"
  3. Using GDS, check if there is an error in ABS/ESP system.

    If there is an error in ABS/ESP system, first do a troubleshooting for those system and then check BSD system.

  4. Are any DTCs present?

    YES 

    • Go to next procedure.

    NO 

    • Fault is intermittent and caused either by poor contact in connectors or wiring harness, or it has been repaired and BSD ECU memory is not cleared yet. Thoroughly check all connectors (and connections) for looseness, bending, corrosion, contamination, deterioration, and/or damage.
    • Repair or replace as necessary and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.
scientia non olet · About LEMON Manuals