Verification of Vehicle Repair

After a repair, it is essential to verifying that the fault has been corrected.

1. Turn IG On again.
2. Turn BSD Off and On three times. (When you turn BSD on, maintain on state for about 3s.)
3. Connect GDS and select "Diagnostic Trouble Codes(DTC)" mode.
4. Using a GDS, Clear DTC.
5. Operate the vehicle within DTC Enable conditions in General Information.
6. Are any DTCs present?

   YES 

   • Go to the applicable troubleshooting procedure.

   NO 

   • System is performing to specification at this time.