DTC Information And Inspection: DTC Detecting Condition
WARNING: This page is about a different variant/trim than selected.
| Trouble Shooting |
Condition |
Possible Cause |
| DTC Strategy |
- There is enough force on shift motor2 but not enough motion of gear actuator finger is detected while engaging 2nd gear
|
- Faulty DCT
- Mechanical failure on gear2 shift direction
- Matching failure due to clutch2 stuck
|
| Enable Condition |
- When 2nd gear is engaged
- Battery Voltage higher than 10V
- Shift motor 2 voltage higher than 9V
- No electrical failure on shift motor 2
|
| Threshold Value |
- Shift motor 2 force higher than 900N
- Shift motor 2 motion less than 0.1419 mm
|
| Detecting Time |
|
| Fail Safe |
- Drive at Odd gear (1/3/5/7)
|