DTC Information And Inspection: DTC Detecting Condition
WARNING: This page is about a different variant/trim than selected.
| Trouble Shooting |
Condition |
Possible Cause |
| DTC Strategy |
- There is enough force on shift motor1 but not enough motion of gear actuator finger is detected while engaging 1st gear
|
- Faulty DCT
- Mechanical failure on gear1 shift direction
- Matching failure due to clutch1 stuck
|
| Enable Condition |
- When 1st gear is engaged
- Battery Voltage higher than 10V
- Shift motor 1 Voltage higher than 9V
- No electrical failure on shift motor 1
|
| Threshold Value |
- Shift motor 1 force higher than 900N
- Shift motor 1 motion less than 0.1419 mm
|
| Detecting Time |
|
| Fail Safe |
- Drive at Even gear (2/4/6/R)
|