| Main action |
|
- Poor contact of connector
- Controller power supply failure
- Faulty ESP (ESC)
|
| Threshold value |
- When a hardware error in the ESP (ESC) module is detected.
* Hardware error:
- RAM/ROM's Bit error Monitoring
- Stack over/under flow Monitoring
- Main MCU & ASIC Communication Monitoring
- Interrupt/Timer/CPU Calculation Monitoring
- MCU Self test monitoring
|
| Diagnosis time |
|
| MIL |
- ABS/ESP (ESC)/EBD warning lamps are activated
|
| Reset condition |
- When the normal state is confirmed after ignition switch turned OFF and back ON.
|