| Main action |
- Monitor the pressure sensor signal
|
- External Noise
- Faulty ESP (ESC)
- Poor pressure due to air remaining in the brake system
|
| Threshold value |
- In case of normal status, no braking input, no motor operation, no low voltage, driving more than 10 km/h (6.2 MPH) and Accelerator position sensor value is greater than 40%, the system detects a fault if filtered input values of sensor keep over 15 bar for 2.4 seconds
|
| MIL |
- ESP (ESC) warning lamp is activated
|
| Reset condition |
- When pressure sensor offset value is below 15 bars. After ignition switch turned OFF and back ON, driving more than 10 km/h (6.2 MPH) Accelerator position sensor value is higher than 20% and no brake lamp signal.
|