| Main action |
- Monitor the wheel speed sensor signal
|
- Improper installation of wheel speed sensor
- Large Air-Gap
- Installation of wrong type Wheel speed sensor
- Faulty Wheel speed sensor
- Tone wheel with wrong number of teeth
- Abnormal tire size
- Faulty ESP (ESC)
|
| Threshold value |
Case 1 |
- If one of wheel speeds is less than 2.75 km/h (1.7 MPH) when the vehicle speed is greater than 12 km/h (7.4 MPH).
- Fault detection time: When the fault occurs for more than 1 second
- Detection area: When driving more than 12 kph for the first time
- When the vehicle is stopped and restarted, it is redetected at 12 km/h (7.45 MPH).
- Even though every wheel speed is normal in case of above, a failure is detected when one of wheel speeds is less than 2.75 km/h (1.7 MPH) during vehicle acceleration or deceleration from 12 km/h (7.4 MPH).
|
| Case 2 |
- A failure is detected when there is a difference of wheel speeds due to air gap or tone wheel failure (missing teeth).
- FL/RL, FR/RR: 6 km/h~12 km/h (3.7~7.4 MPH)
FL/FR: 10 km/h~16 km/h (6.2~9.9 MPH)
Fault detection time: maximum 20 seconds
- FL/RL, FR/RR: >12 km/h (7.4 MPH)
FL/FR: > 16 km/h (9.9 MPH)
Fault detection time: maximum 10 seconds
- Fault detection time is maximum 80 seconds when spin occurs on front wheel.
|
| Case 3 |
- A failure is detected when sensor failure of smart sensor or installation of wrong type sensor.
- When Invalid pulse that does not correspond to the specifications of the smart wheel sensor is input for more than 50 times. (Vehicle Stop or Driving condition)
- When the type of the wheel sensor mounted on the vehicle does not match the specification (vehicle stop condition).
Fault detection time: maximum 2.5 seconds
|
| MIL |
|
| Reset condition |
- After ignition switch turned OFF and back ON, when all wheel speed is normal after driving more than 12 km/h (7.45 MPH).
|