LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2021 >> Elantra SE >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> Front Bumper And Radiator Grille (Except HEV) >> Radiator Grille >> Repair Procedures >> Replacement >> N Line

N Line

CAUTION:
  • When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
  • Put on gloves to prevent hand injuries.
NOTE:
  • Take care not to bend or scratch the bumper cover and panels.
  1. Remove the front bumper assembly.

    (Refer to "FRONT BUMPER ASSEMBLY ")

  2. Detach the wiring (A) mounted on the front bumper assembly and energy absorber.
    G14599740Courtesy of HYUNDAI MOTOR AMERICA
  3. Remove the front bumper energy absorber (A).
    G14599741Courtesy of HYUNDAI MOTOR AMERICA
  4. Loosen the mounting screws, remove the radiator grille upper cover (A).
    G14599742Courtesy of HYUNDAI MOTOR AMERICA
  5. Remove the front bumper lip (A).
    G14599743Courtesy of HYUNDAI MOTOR AMERICA
  6. Loosen the mounting screws, remove the front bumper grille (A).
    G14599744Courtesy of HYUNDAI MOTOR AMERICA
  7. Loosen the mounting screws, remove the front bumper molding (A).
    G14599745Courtesy of HYUNDAI MOTOR AMERICA
  8. Loosen the mounting screws, remove the radiator grille (A).
    G14599746Courtesy of HYUNDAI MOTOR AMERICA
  9. To install, reverse the removal procedure.

    Information 

    • Make sure the connector is connected properly.
scientia non olet · About LEMON Manuals