DTC Information And Inspection: DTC Detecting Condition
WARNING: This page is about a different variant/trim than selected.
| Item |
Detecting Condition |
Possible Cause |
| DTC Strategy |
- Characteristic Monitoring
|
- Poor connector connection
- Faulty HO2S
- Restricted of fuel filter in fuel pump
- Faulty PCM
|
| Enable Condition |
- Wide range sensor pump current valid
- Downstream O2 sensor operative readiness
- Active test not activated
- Engine speed is higher than 600 RPM
- Mass air flow is lower than 83g/s (300kg/h)
- Exhaust gas temperature is at between 300°C (572°F) and 800°C (1472°F)
|
| Threshold Value |
- Plausibility between upstream and downstream
- Upstream lean & downstream rich & lambda controller limit or upstream rich & downstream lean & lambda controller limit
|
| Diagnostic Time |
|
| MIL ON Condition |
|