LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2021 >> Elantra N Line, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 35 (Engine Control System Diagnosis - 2.0L (Except HEV) (4 Of 6)) >> DTC P061A-00: Internal Control Module Torque Performance >> DTC Information And Inspection >> DTC Detecting Condition

DTC Information And Inspection: DTC Detecting Condition

WARNING: This page is about a different variant/trim than selected.
Item Detecting Condition Possible Cause
DTC Strategy
  • Check internal PCM
  1. Poor connector connection
  2. Faulty PCM
Enable Condition
  • Ignition "ON" or engine running Engine speed is higher than 32 RPM
Threshold Value
  • Actual value is higher or lower than allowable range (ADC monitoring or Engine speed ratio monitor or Idle speed controller monitor or torque loss monitor or Min/Max Clutch torque monitor or Pedal value monitor or TPS ratio monitor or Mass fuel flow monitor errors)
Diagnostic Time
  • 0.48 seconds
MIL ON Condition
  • 1 driving cycle
scientia non olet · About LEMON Manuals