LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2021 >> Elantra N Line, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 35 (Engine Control System Diagnosis - 2.0L (Except HEV) (4 Of 6)) >> DTC P0606-00: ECM/PCM Processor >> DTC Information And Inspection >> DTC Detecting Condition

DTC Information And Inspection: DTC Detecting Condition

WARNING: This page is about a different variant/trim than selected.
Item Detecting Condition Possible Cause
DTC Strategy
  • Controller malfunction check failure of controller operation
  1. Poor connector connection
  2. Faulty PCM
  3. Programming error
Enable Condition
  • Battery voltage is at between 10 and 16V
  • Sensor heater controller active
Threshold Value
  • Error bit information from H/W circuit
Diagnostic Time
  • 5s
MIL ON Condition
  • 2 driving cycles