DTC Information And Inspection: DTC Detecting Condition
WARNING: This page is about a different variant/trim than selected.
| Item |
Detecting Condition |
Possible Cause |
| DTC Strategy |
- CAM operating angle rationality check during cold start
|
- Poor connector connection
- Engine oil contamination
- Oil leakage
- Faulty intake VFS circuit
- Faulty intake VFS
|
| Enable Condition |
- VVT control operation status
- Cumulative crank revolutions above the threshold (40 to 80 revolutions: depending on coolant temperature)
- Engine speed above 680 and 1080 RPM
- Engine oil temperature above -5°C (23°F)
- Catalytic heating state
|
| Threshold Value |
- Difference between the target CAM angle and actual CAM angle is more than 6°
|
| Diagnostic Time |
- 8 seconds (once per driving cycle)
|
| MIL ON Condition |
|