LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2021 >> Elantra N Line, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 35 (Engine Control System Diagnosis - 2.0L (Except HEV) (4 Of 6)) >> DTC P050B-00: Cold Start Ignition Timing Performance >> DTC Information And Inspection >> DTC Detecting Condition

DTC Information And Inspection: DTC Detecting Condition

WARNING: This page is about a different variant/trim than selected.
Item Detecting Condition Possible Cause
DTC Strategy
  • Ignition efficiency Monitoring during catalyst heating
  1. Poor connector connection
  2. Intake system limitations
  3. Vacuum leakage
  4. Exhaust clogging
  5. Engine mechanical problems
  6. Throttle body contamination
  7. Faulty ETC
Enable Condition
  • More than 3 seconds after entering the catalyst heating
  • Barometric pressure is higher than 750 hPa
  • Vehicle speed is same as 0 km/h (0 mph)
  • Engine load less than 55%
Threshold Value
  • Deviation of average ignition efficiency during 10s (Actual efficiency-Target efficiency) Is higher than threshold
Diagnostic Time
  • 10 seconds (once per driving cycle)
MIL ON Condition
  • 2 Driving Cycles