LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2021 >> Elantra N Line, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 18 (Engine Control System - 2.0L (Except HEV)) >> Electric Exhaust Gas Recirculation (EEGR) Control Valve >> Repair Procedures >> Inspection >> [Motor]

Repair Procedures: Inspection: [Motor]

WARNING: This page is about a different variant/trim than selected.
  1. Turn the ignition switch OFF.
  2. Disconnect the EEGR valve connector.
  3. Check that the EEGR valve is stuck by foreign material.
  4. Measure resistance between motor 4 and 5 control terminals of the motor.
  5. Check that the resistance is within the specification.
Item Specification
Coil Resistance (Ω) 2.21 - 2.99 [20°C (68°F)]