LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2021 >> Elantra N Line, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 18 (Engine Control System - 2.0L (Except HEV)) >> ETC (Electronic Throttle Control) System >> Repair Procedures >> Inspection >> ETC Motor

ETC Motor

WARNING: This page is about a different variant/trim than selected.
  1. Turn the ignition switch OFF.
  2. Disconnect the ETC module connector.
  3. Measure resistance between the ETC module terminals 1 and 2, terminals 3 and 6.
  4. Check that the resistance is within the specification.

    Specification:  Refer to "SPECIFICATION "

scientia non olet · About LEMON Manuals