LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2021 >> Accent SEL >> Repair and Diagnosis >> Brakes >> Traction Control >> Abs/ESC System Diagnosis (2 Of 2) >> DTC C1611-08: CAN Time-Out EMS >> Component Inspection

Component Inspection

  1. Connect GDS and select "Diagnostic Trouble Codes (DTC)" mode.
  2. Turn "ON" the ignition switch.
  3. Using a GDS, Clear DTC.
  4. Turn "OFF" the ignition switch.
  5. Disconnect ECU's connector connected to CAN bus.
  6. Turn "ON" the ignition switch.
  7. Connect GDS and select "Diagnostic Trouble Codes (DTC)" mode.
  8. Are any DTCs present?

    YES 

    • Go to step  1 of the component inspection and disconnect another ECU's connector connected to CAN bus in step 5.
    • Repeat above step until test completed on all ECU in CAN bus.
    • If DTC is present after above test, substitute with a known-good PCM (ECM) and check for proper operation. If problem is corrected, replace PCM (ECM) and then Go to "VERIFICATION OF VEHICLE REPAIR " procedure.

    NO 

scientia non olet · About LEMON Manuals