Ground Circuit Inspection
- Turn the ignition switch & engine "OFF"
- Disconnect the Interior Antenna #3 (trunk antenna) connector.
- Measure the resistance between chassis ground and the ground circuit of the Interior Antenna #3 (trunk antenna).
Specification: Approx. below 1 Ω
- Is the result within specifications?
YES
- Replace the Interior Antenna #3 (trunk antenna) with an usable sample and check for proper operation.
If it works properly, put it in place and then go to "VERIFICATION OF VEHICLE REPAIR ".
NO
- Inspection the circuit for an open. Repair relevant component(s) as necessary and then go to "VERIFICATION OF VEHICLE REPAIR ".