Open or Short Check
- Turn "ON" the ignition switch.
- Press the brake pedal.
- Measure voltage between brake light switch signal 'A' terminal of the ESP (ESC) harness connector and chassis ground.
Specification: Brake light switch 'A': Battery (+) voltage
- Is the result within specifications?
YES
- Go to "Signal Circuit Inspection (brake pedal is not depressed)" procedure.
NO
- Check for open or blown fuse referring to "Circuit Diagram".
- Repair open or short in power circuit between battery and ESP (ESC) harness connector and then Go to "VERIFICATION OF VEHICLE REPAIR " procedure.