Ground Circuit Inspection
- Ignition "OFF".
- Disconnect battery (-) connector.
- Disconnect rear camera connector.
- Measure the resistance between ground terminal of rear camera harness connector and chassis ground.
Specification: Approx. 1Ω below.
- Connect battery (-) cable.
- Parking brake "ON" & Ignition "ON" & Gear Position "R".
- Measure the voltage between power terminal of rear camera harness connector and chassis ground. (A)
- Measure the voltage between power terminal and ground of rear camera harness connector. (B)
Specification: Difference in (A) and (B) is less than 200 mV
- Is the measured value within specification?
YES
- Go to "COMPONENT INSPECTION " procedure.
NO
- Repair open or short in ground circuit and then Go to "VERIFICATION OF VEHICLE REPAIR " procedure.