LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2021 >> Accent SEL >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Drivers Assistance Systems - ADAS >> Autonomous Emergency Braking System Diagnosis >> DTC C1205-81: Wheel Speed Sensor Front-RH Invalid/No Signal >> Wiring Inspection >> C-CAN communication line Inspection >> Check Open in CAN communication Line

Check Open in CAN communication Line

  1. Turn the Ignition switch 'OFF'.
  2. Disconnect ABS/ESP Module connector and AEB (SCC) Module connector.
  3. Measure the resistance between C-CAN High terminal of ABS/ESP Module harness connector and C-CAN High terminal of AEB (SCC) harness connector.
  4. Measure the resistance between C-CAN Low terminal of ABS/ESP Module harness connector and C-CAN Low terminal of AEB (SCC) harness connector.

    Specification:  Below 1Ω

  5. Is the measured value within specification?

    YES 

    • Check ABS/ESP, AEB (SCC) Module connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary, and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.

    NO 

scientia non olet · About LEMON Manuals