Repair Procedures: Installation
WARNING: This page is about a different variant/trim than selected.
- To install, reverse the removal procedures.
NOTE:
- Carefully install the clamp not to damage the hose.
- Install the clamp in a correct direction not to be interfered with other parts.
- After the installation, start the engine and then check if there are any leakages from the hose.
- Then finish check the IVTF level procedure and refill the IVT fluid.
(Refer to Hydraulic System, level check - "REPAIR PROCEDURES ")
- Injection the coolant.
(Refer to Engine Mechanical System - "COOLANT ")