DTC Information And Inspection: DTC Detecting Condition
WARNING: This page is about a different variant/trim than selected.
| Troubleshooting |
Condition |
Possible Cause |
| Main Action |
- Monitor the motor operation
|
- Open or short in power supply circuit
- Blown fuse
- Faulty IEBM
- Excessive parking brake shoe gap
|
| Case 1 |
Threshold Value |
- Calculated motor overheat protection index is less than the motor overheat protection degraded mode entrance threshold
- Estimated motor coil temperature is greater than or equal to 180'C (356°F)
|
| Reset Condition |
- When estimated motor overheat protection index goes up to 80% of max motor overheat protection index
|
| Case 2 |
Threshold Value |
- Calculated motor overheat protection index is less than the motor overheat protection fallback mode entrance threshold
- Estimated motor coil temperature is greater than or equal to 190'C (374°F)
|
| Reset Condition |
- There is no recovery in the same ECU power cycle
|
| MIL |
- ABS/ESC/IEB/RBS/DBC/AVH warning lamps are activated
|
NOTE:
* IEBM (Integrated Electric Brake Module: ESP Control Module)