DTC Information And Inspection: DTC Detecting Condition
WARNING: This page is about a different variant/trim than selected.
| Troubleshooting |
Condition |
Possible Cause |
| Main Action |
|
- Faulty IEBM
- Variant coding is not finished.
- A different type control module is installed
- CAN Bus OFF
|
| Case 1 |
Threshold Value |
- When variant coding is not completed
- When 2WD vehicle receives 4WD messages
|
| MIL |
- EBD/ABS/ESP (ESC)/DBC/AVH warning lamps are activated
- EPB warning lamp is not activated
|
| Case 2 |
Threshold Value |
- When variant coding is not completed
- When non-Ax variant vehicle receives Ax messages
|
| MIL |
- EBD/ABS/ESP (ESC)/DBC/AVH warning lamps are activated
- EPB warning lamp is not activated
|
| Case 3 |
Threshold Value |
- When variant coding is not completed
- When non-EPB vehicle receives EPB messages
|
| MIL |
- EBD/ABS/ESP (ESC)/DBC warning lamps are activated
- AVH warning lamp is not activated
|
| Case 4 |
Threshold Value |
- When variant coding is not completed
- When AEB status signal is received after AEB function is coded as not being applied
- When a non-AEB status signal is received after the AEB function is encoded as applied
|
| MIL |
|
| Case 5 |
Threshold Value |
- When variant coding is not completed
- When SCC status signal is received after SCC function is coded as not being applied
- When a non-SCC status signal is received after the SCC function is encoded as applied
|
| MIL |
|
| Case 6 |
Threshold Value |
- Additional function (ESS/SPAS/AVH/HAC/EPB) configuration is not coded
|
| MIL |
- EBD/ABS/ESP (ESC)/DBC warning lamps are activated
- EPB warning lamp is not activated
|
| Reset Condition |
- DTC is cleared and W/Lamp is off after calibration is done
|
NOTE:
* IEBM (Integrated Electric Brake Module: ESP Control Module)