DTC Information And Inspection: DTC Detecting Condition

WARNING: This page is about a different variant/trim than selected.

Troubleshooting	Condition	Possible Cause
Main Action	Monitor the CAN circuit	Short circuit between CAN bus lines Short to ground or other voltage in CAN bus line Faulty IEBM Poor connector connection
Threshold Value	When C-CAN bus OFF is detected for the first time, CAN communication is initialized and spends 70 milliseconds for recover. A failure is detected if the CAN bus OFF state occurs more than error filtering time * In control: 2 times/Non control: 10 times
MIL	ESC/AVH/DBC warning lamps are activated EBD/RBS/ABS/IEB/EPB warning lamps are not activated
Reset Condition	When bus-off is recovered after ignition switch OFF and back ON

NOTE: * IEBM (Integrated Electric Brake Module: ESP Control Module)