LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2020 >> Sonata SEL >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 31 (Abs/ESC Diagnosis (HEV) (2 Of 2)) >> DTC C1614-08: CAN Time-Out HCU/VCU/FCU >> DTC Information And Inspection >> DTC Detecting Condition

DTC Information And Inspection: DTC Detecting Condition

WARNING: This page is about a different variant/trim than selected.
Troubleshooting Condition Possible Cause
Main Action
  • Monitor the CAN message
  1. Faulty HPCU
  2. Open/short in CAN communication line
  3. Poor connector connection
  4. Other ECUs incorrectly occupy the CAN bus
Threshold Value  
  • In case that HCU message is not received for more than specific time
  • Specific time: In control = 500 milliseconds

    Non control = 1, 500 milliseconds

MIL
  • ESC/AVH/DBC/EPB warning lamps are activated
Reset Condition
  • When normal CAN signal is received for more than 500 milliseconds after ignition is turned OFF and ON again
NOTE: * IEBM (Integrated Electric Brake Module: ESP Control Module)