DTC Information And Inspection: DTC Detecting Condition

WARNING: This page is about a different variant/trim than selected.

Troubleshooting	Condition	Possible Cause
Main Action	Monitor the CAN message	Open or Short circuit in CAN line Faulty IEBM Poor connector connection
Threshold Value	When P-CAN bus off is detected for the first time, CAN communication is initialized and spends 70 milliseconds for recover. A failure is detected if the CAN bus off state occurs more than error filtering time * In control: 2 times/Non control: 10 times
MIL	ESC/RBS/AVH/DBC/EPB warning lamps are activated EBD/ABS/IEB warning lamps are not activated
Reset Condition	When bus-off is recovered after ignition switch OFF and back ON

NOTE: * IEBM (Integrated Electric Brake Module: ESP Control Module)