DTC Information And Inspection: DTC Detecting Condition

WARNING: This page is about a different variant/trim than selected.

Troubleshooting		Condition	Possible Cause
Main Action		Internal monitoring	Poor contact of connector Controller power supply failure Faulty IEBM
Threshold Value	Case 1 (MCU)	In case of fault in MCU internal device Faulty EEPROM Faulty RAM, ROM Faulty MCU Trap Faulty Stack overflow Faulty Cycle time over Faulty ADC converter Faulty Oscillator Faulty PFM Faulty MPU Faulty 3.3V internal power supply
Threshold Value	Case 2 (ASIC)	In case of fault detection by ASIC Faulty Configuration Faulty SPI Faulty ASIC Power Faulty ASIC Current Faulty Charge pump Faulty Oscillator Faulty NVM
MIL		EBD/ABS/ESC/IEB/RBS/DBC/AVH/EPB warning lamps are activated
Reset Condition		When the normal state is confirmed after ignition switch turned OFF and back ON

NOTE: * IEBM (Integrated Electric Brake Module: ESP Control Module)