DTC Information And Inspection: DTC Detecting Condition
WARNING: This page is about a different variant/trim than selected.
| Troubleshooting |
Condition |
Possible Cause |
| Main Action |
- Monitor the brake switch signal
|
- Blown Fuse
- Defected brake switch
- Poor power supply for brake switch
- Short to power in brake switch
- Open or short to ground in brake switch
- Poor installation of the brake switch
- Defected ESP (ESC)
- Faulty of Master cylinder pressure
|
| Threshold Value |
Case 1 |
- When brake switch is "ON" for 6 minutes, vehicle speed over 20 km/h (12.5 MPH), brake pedal value less than 6 mm, and brake pedal pressure less than 0.5 bar
|
| Case 2 |
- When brake switch is "OFF" for 3 seconds, brake pedal value over 25 mm and brake pedal pressure more than 5 bar
|
| MIL |
- ESP (ESC) warning lamp is activated
|
| Reset Condition |
- After turn ignition switch OFF and back ON, put on (1 second) and OFF (1 second) the brake pedal
|
NOTE:
* IEBM (Integrated Electric Brake Module: ESP Control Module)